User's Manual

OPERATION
15
Testing the Shade
Use the manual control button to test the shade and
ensure that the motor and power source are working
correctly.
■ Press the manual control button to lower the
shade. If the shade does not operate, see
“Troubleshooting” on page20.
■ Test vane operation by pressing the manual control
button to open the vanes and then pressing it again
to close the vanes.
■ After the vanes are fully closed, press the manual control button to raise the shade.
CAUTION: When raising the shade for the first time, observe how the fabric rolls up into
the headrail. It should roll up evenly. If the bottom rail is not level or the shade starts to rub
against either window jamb, immediately press the manual control button to stop the shade.
See “Adjust the Bottom Rail Weight” on page23.
■ Two-On-One Headrail Shades have two motors and two battery packs. The right motor
operates the right shade and the left motor operates the left shade. Use the manual control
buttons on each side to test the two shades individually.
Using the PowerView
™
Remote
First, activate the remote by pulling both plastic tabs from the back battery compartment.
IMPORTANT: If you have more than one remote, see “Adding Additional Remote(s) to the
PowerView
™
Shade Network” in the PowerView Motorization Remote Control Guide.
Group 1
Group 2
OPEN
CLOSE
Group 3
Group 4
Group 5
Group 6
Favorite
(Shading/vane position)
LEFT
ARROW
T
ilts vanes closed
RIGHT ARROW
Tilts vanes open
STOP
(Press and hold for
programming mode)