User's Manual

OPERATION

Further Operation and Programming Information

PowerView

™

Pebble

™

Remote and/or PowerView Surface Remote Operation

For information regarding operation and programming of the PowerView remote, refer to your

PowerView Motorization Remote Control Guide.

PowerView Scene Controller

For information regarding operation and programming of the PowerView Scene Controller, refer

to your PowerView Motorization Scene Controller Guide.

PowerView App Operation

The PowerView Hub is required for PowerView App operation. For information regarding setup

and operation using the PowerView App, refer to the online PowerView App Software Guide at

hunterdouglas.com/powerview/support.

Resetting the Shade (If Necessary)

Basic Reset

The basic reset is used to reset the shade’s travel limits.

1. Press and hold the manual control button for 6 seconds. The shade will move slightly.

2. Release the manual control button. The shade will raise to its fully open position to set the

upper travel limit, then lower to the fully closed position with vanes open to set the lower

travel limit. The shade will move slightly one more time to indicate that the travel limits have

been reset.

Resetting Shade Programming

This reset erases all shade programming from memory, including group assignments, preventing

any input device from operating the shade. Its primary use is during installation to correct group

and network assignments. This reset does not affect travel limits.

1. Press and hold the manual control button for 12 seconds. The shade will move slightly after 6

seconds, then again after 12 seconds. Release the button.

2. Refer to “Joining a Shade to a Group” on page 18 to program the shade to a group.