User's Manual

AVOIDING INADVERTANT PROGRAMMING
TIP 1 Place wireless wall switch as close as possible to the
IR receiver eye.
TIP 2
Program window covering(s) prior to installation.
TIP 3
Remove power from window covering(s) not
being programmed.
ENTERING PROGRAM MODE
To activate Program Mode, use a paper clip to quickly press and
release the PROGRAM button located on the back of the wireless
wall switch.
The Program Mode is indicated by the BLINKING
GREEN ALL button and will stay active for approximately
30 seconds before timing out.
WINDOW COVERING OPERATION
Window coverings may not be operated while in the Program
Mode.
Do not operate window coverings when the ALL button
is BLINKING GREEN.
EXITING PROGRAM MODE
To exit Program Mode before the 30-second time-out,
quickly
press and release the PROGRAM button a second time. The ALL
button will stop BLINKING GREEN. The switch may now be used
to operate your window covering(s).
INFRARED (IR) CHANNEL 2
Wireless Wall Switch will not operate window coverings set to
operate on IR Channel 2.
SATELLITE EYE
The satellite eye only needs to be visible during the RF programming
phase.
Once programming has been completed the satellite eye
can be hidden out of sight.
Refer to the product Installation, Operation and Care for further
details about Platinum
™
Technology.
10 hunterdouglas.com
Notes on Programming