User's Manual

Programming RF Groups
hunterdouglas.com 5
1
2
PROGRAM MODE
Remove the back cover of the
wireless wall switch.
Use a
paper clip to press and quickly
release the PROGRAM button
on the back of the switch. The
ALL button on the front of the
switch will BLINK GREEN (for
approximately 30 seconds).
GROUP NUMBER
While the ALL button is
BLINKING GREEN,
press
the GROUP number (1–4)
to which you are adding the
window covering.
UP BUTTON
Point the switch at the IR
receiver eye built into the
headrail or satellite eye of the
window covering and press the
UP button. The unit will raise or
“jog” to show that it has been
programmed into a group.
EXIT PROGRAM MODE
Press the PROGRAM button a
second time to exit Program
Mode.
The ALL button on the
front of the switch will turn off.
Repeat steps to program other
window coverings.
BEFORE YOU BEGIN
Partially lower, traverse or
tilt the window covering to
ensure functionality
.
TIP 1 When programming
a window covering to the
switch, place it as close as
possible to the IR receiver eye.
TIP 2
There are only
four distinct groups that
can be programmed to a
Platinum
™
wireless
wall switch.
TIP 3
IR mode is only active
in Program mode.
3
4