Installation Instructions

9
10
1886
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Bulbs/Glass Remote CradleRemote
Preparing the Remote Control
The remote control is already
paired for use.
To access the battery compartment, remove the small
Phillips head screw that secures the battery door to
the transmitter assembly. Install one 3-Volt, CR2032
battery, found in the remote control hardware bag,
into the transmitter. Clean the battery contacts and
also those of the device prior to battery installation.
The battery should be installed with the positive (+)
side up. Please contact your local battery recycling
center for proper battery disposal information.
NOTICE
• Always purchase the correct size and grade of
battery most suitable for the intended use.
• Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the
device prior to battery installation.
• Ensure the batteries are installed correctly with
regard to polarity (+ and -).
• Remove batteries from equipment which is not to
be used for an extended period of time.
• Remove used batteries promptly.
Battery Door
Battery
Screw
Using the Remote Control Cradle
Your remote comes with
a wall plate that has two
posts on which to mount
your remote transmitter
when not in use.