User Manual

www.HunterFan.com
1.888.830.1326
Within 3 minutes of restoring power
to the fan, press both the Fan Off
button and the High button for at
least 4 seconds. Your fan will turn on
low to indicate successful syncing.
If it does not, turn off power to your
fan, wait 1 minute then try again. If
using the transmitter with multiple
fans, repeat this process for each fan.
Note: The remote must be paired
before the fan will operate.
Fan Off
High
To install the transmitter cradle,
remove the two screws holding
your switch cover plate. Do not
remove the cover plate. Orient
the cradle by lining up the two
mounting holes with those on the
cover plate. Insert and tighten the
screws. Do not over tighten.
The Fan Off button only turns the
fan off. To turn the fan on, press one
of the fan speed buttons.
High
Medium
Low
Operation, Maintenance, & Cleaning
ON
Turn Power
To access the battery compartment,
remove the small Phillips head screw
that secures the battery door to the
transmitter assembly. The battery
should be installed with the positive
(+) side up. Replace with a CR2032
battery when necessary.
Phillips
Head
Screw
Battery
Door
ooo
oo
o
Low
Medium
High
Fan Off
If you are installing multiple remote-controlled fans on the same
circuit breaker, go to www.HunterFan.com/FAQs and click “How do I
properly install multiple remote-controlled fans?” for more information.
15
M0074-01 • 05/14/14 • © Hunter Fan Company