User Manual

16
INSTALLATION
RETENTION SYSTEM
5
A A
Secure rst clamp on the
loose end of the cable.
Secure the second clamp to the
cable approximately 6” from
the rst clamp.
B
Secure remaining cable to itself
with cable clamps.
A
Wrap retention cable around
building structure that can
withstand double the installed
fan weight. Use mounting slot in
the canopy to allow the retention
cable to pass out of the canopy
and through the gasket.
CRUSH HAZARD. To prevent serious injury or death, ALWAYS attach the
Retention Cable to the fan motor and secure to the building structure
on EVERY fan.
Live End
Dead End
Leave approximatlely 3” of slack in
the wire and the cable, at the top of
the downrod opening.
When attaching cable clamps, remember: “Never saddle a dead horse.”
Place the u-bolt on the “dead” end of the Retention Cable and the saddle on the “live” portion of the
Retention Cable. If done incorrectly, the U-bolt could crush the wire when tightened and can reduce the strength of the wire.
NOTICE
NOTICE
H
H
I
I
Small End