User Manual

20
INSTALLATION
REMOTE CONTROL
9
A
To access the battery compartment, remove the
small Phillips head screw that secures the battery
door to the transmitter assembly. The battery should
be installed with the positive (+) side up. Replace
with a CR2032 battery when necessary.
The remote transmitter is already paired to the
receiver and ready to use.
Note: If you would like to operate multiple fans or
multiple remotes, or if your remote is not working,
please see the Troubleshooting section at the end of
this manual.
B
Your remote comes with three mounting options.
B.1
Option one is a wall
plate that has two posts
on which to mount your
remote transmitter
when not in use.
B.2
Option two and three use an extended wall plate
that replaces your pre-existing light switch plate.
Option two combines the extended wall plate with
an additional plate that has two posts on which to
mount your remote transmitter when not in use.
Install the extended wall plate. Then install the
secondary plate to the extended wall plate.
B.3
Option three adds two cradle arms overtop
of the remote transmitter onto the extended
wall plate. This locks the remote transmitter
into place so that it can only be removed by
removing the two cradle arms.
Press = Fan Off
Single Press = Set Fan to Speed 1
Press Twice= Set Fan to Speed 2
Single Press = Set Fan to Speed 3
Press Twice = Set Fan to Speed 4
Single Press = Set Fan to Speed 5
Press Twice = Set Fan to Speed 6
Single Press = Set Fan to Speed 7
Press Twice = Set Fan to Speed 8
Single Press = Incremental Light Output 10%
Long Press = Light On Output 100%
Single Press = Decremental Light Output 10%
Long Press = Light Off
Slide Up = Updraft
Slide Down = Downdraft
Phillips
Head
Screw
Battery
Door
A
Toggle dimming mode by holding OFF ( ) and quickly press
Light Down ( ) two times
NOTICE
x2 x2
x2
x2
x4