3 CFL Bowl Light Kit Installation Manual Model 99098, 99099 Compatible with: 2xxxx Types A - Z 51000-58999 fan series 59500-59999 fan series Select Casablanca Fans MA009-01 • 08/02/13
1.888.830.1326 BEFORE YOU BEGIN Read entire installation instructions carefully before beginning installation and save these instructions. Switch Housing Your light kit is compatible with most ceiling fans. The light kit will attach to the fan’s switch housing. Begin on page 3 where you will choose the type of switch housing that most closely resembles the one on your fan. From there, you will be directed to the set of assembly instructions that are appropriate for installing the light kit to your fan.
1.888.830.1326 WHICH ASSEMBLY METHOD WILL I USE? Choose one of the four images below that most closely resembles the switch housing on your fan; then follow the instructions under the image. Switch Housing Screw Cap Screw Switch Housing Switch Housing Cap Switch Housing Screw If your fan’s switch housing cap resembles this one, remove the whole switch housing by removing the switch housing screws with a Phillips head screwdriver.
1.888.830.1326 TYPE-A ASSEMBLY INSTRUCTIONS 1 2 Light Kit Screw Switch Housing Wiring Harness Light Kit Cap Wire Connector Light Fixture If your fan does not have pin connectors on the wires coming from the switch housing, install the wiring harness provided. Using the provided wire connectors connect the white wire from the fan to the white wire from the wire harness and connect the black or blue wire from the fan to the black wire from the wire harness.
1.888.830.1326 TYPE-A ASSEMBLY INSTRUCTIONS (CONTINUED) 5 6 Fan Pull Chain Grommeted Hole Switch Housing Screw Light Pull Chain Lift the light kit assembly up so that the screw holes in the lower switch housing line up with the holes in the upper switch housing. Install the switch housing screws and tighten securely. 7 If necessary, attach the extension chain provided to the fan pull chain coming from the switch housing.
1.888.830.1326 TYPE-B ASSEMBLY INSTRUCTIONS 1a 1b OR Switch Housing Pin Connectors If your fan does not have pin connectors on the wires coming from the switch housing, go to step 2. If the fan has pin connectors, cut the wires just above the fan pin connectors with wire cutters. Discard the pin connectors. Go to step 2. 2 3 Wire Connector Washer and Nut Threaded Rod Switch Housing Wiring Harness Feed the wires through the switch housing cap, washer, and nut.
1.888.830.1326 TYPE-B ASSEMBLY INSTRUCTIONS (CONTINUED) 4 5 6 Fan Pull Chain Bad Wolf Switch Housing Screw Using the single pin connectors, connect the black or blue wire from the fan to the black wire from the light kit. Connect the white wire from the fan to the white wire from the light kit. 7 Upper Switch Housing Lift the light kit assembly up so that the screw holes in the lower switch housing line up with the holes in the upper switch housing.
1.888.830.1326 TROUBLESHOOTING Lights don’t come on. • Make sure that the bulbs are properly installed. • Make sure power switch is on. • Pull the pull chain to make sure it is on. • Check the circuit breaker to ensure the power is turned on. • Check the pin connections in the light kit. • Refer to the fan manual for locating the fan’s wiring. Verify that the light and power wires are correctly connected to the ceiling and the light kit.
