Installation & Assembly

9
1886
Installing the Bulb and Glass
ON
Turn Power
Need a little more help with assembling this light?
Visit our light kit video at: http://bit.ly/HunterQuickConnect
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Remote Troubleshooting
Repeat x5
Notch
Some components not shown for visual clarity.
Lift the glass and attach it to
the light xture using the three
thumbscrews. Tighten all three
screws securely by hand.
Install the included bulb
into the socket. When
necessary, replace with
bulb of same wattage.
Canopy Screw
Blade Screw
Grommet
Blade Arm Screw
Want to install your fan without a light kit?
Go to support.hunterfan.com
Hunter Pro Tip:
IMPORTANT
Push the connector and
excess wire into the hole at
the top of the light xture.
The connector and excess wiring
must be pushed into the light
xture in order to successfully
mount the light xture to the fan.
Pin
Raise the light kit to the bottom of the fan.
Align the notch on the mounting ring on the
top of the light kit with the pin in the mounting
bracket on the bottom of the fan.
HOLD HERE
Assembling the Light
Connect the plugs from
the fan and light xture.
Make sure to line up
the colored markings
on the connectors.
Remove the cardboard plug
guard before proceeding!
Give the xture a gentle,
clockwise turn to ensure the
xture is secure and that the
locking pin has engaged.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Fan style may vary.
Note: