User's Manual

14
45056-01 • 10/02/09 • Hunter Fan Company
7 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Uninstalling the Light Fixture
7-14. To uninstall the light xture, rst disconnect the plug connectors
between the black wire and the black wire with a white
stripe.
7-15. Disconnect the plug connectors between the two white
wires.
7-16. Remove the two screws attaching the light kit to the lower
switch housing.
7-17. Remove the light xture from the lower switch housing,
pulling disconnected wires through the hole in the center of
the lower switch housing.
Note: When removing the wires, pull the thin plug
connector (male) through rst, and then pull the other plug
connector (female) through the hole.
7-18. Install the dummy terminals (included in the sack parts) on
the two disconnected wires in the lower switch housing.
7-19. Install the switch housing cap and plug button to the lower
switch housing.
7-20. Once you have uninstalled the light xture, continue
with Step 7-1.
Male Dummy
Terminal
Female Dummy
Terminal
Step 7-19
Cap
Plug Button
Lower
Switch Housing
readed Rod
Steps 7-14 – 7-17