Use and Care Manual

INSTALLATION
GUY WIRES
6
A
Attach beam clamps to structure.
Clip guywire end to beam clamp.
ATTACH GUY WIRE TO BUILDING STRUCTURE WHILE
MAINTAINING A 45-DEGREE ANGLE BETWEEN THE CEILING
AND THE GUY WIRE. DO NOT WRAP GUY WIRES AROUND
THE BUILDING STRUCTURE.
D
Place level against the downrod and
tighten the turnbuckles by hand in
a crisscross pattern. Periodically
checking to make sure fan is level.
Gripple bolt
Turnbuckle
set screw
B
Feed wire through gripple into closed
turnbuckle end and back through
gripple.
E
Tighten bolts on gripples. Tighten set
screws on turnbuckles.
C
Hook turnbuckle to guy wire disc.
Feed guy wires through disc to
hold in place during turnbuckle
installation.
GUY WIRE DISC
A
C
B
D
E
E
13