Use and Care Manual

INSTALLATION
BLADES
7
A
A
To install blade, insert the press
studs through the holes in the blade
holder.
Remember to install with the
numbers facing up.
B
Start the nylon lock nuts onto the
press studs to hold in place.
C
Tighten the nylon locknuts on the the
press studs using the 19mm wrench
or socket.
D
Repeat steps A-C for each of the
three remaining blades.
C
NOTE
The blade is marked with a number to signify
which size fan it goes with. Make sure you match
the correct blade size with the correct motor size.
B
14