Owner's Manual

9
A Hunter Mini-Clik
®
rain sensor or other micro-switch type
weather sensor can be connected to the WVC. The purpose
of this sensor is to stop watering when weather conditions
dictate.
To connect a weather sensor to the WVC:
1. Cut the yellow wire loop attached to the WVC at
approximately the middle of the loop.
2. Remove approximately " (13mm) of insulation from
each wire. Attach each wire to each of the wires of the
weather sensor.
3. Secure both wire connections with waterproof
connectors.
CONNECTING A WEATHER SENSOR ...........................................................
The WVC is easy to program with its companion, the WVP
Wireless Valve Programmer. The easy-to-understand push
button design of the WVP allows you to step through the
process of programming and activating manual watering
with the press of a button. Further information on operating
the WVP can be found in your WVP Owner’s Manual.
PROGRAMMING THE CONTROLLER ...........................................................