User's Manual

sent to the WVC. It will beep twice again indicating the

command was successfully received by the WVC.

To turn the WVC on:

1. While in the programming mode (upper part of the

LCD), press the button until the current time and

day is displayed.

2. Squeeze the Transmit/Receive button once to move

to communication mode (lower part of LCD), use the

and buttons to make sure the arrow is pointed

toward the WVC, then squeeze and hold the Transmit/

Receive button on the WVP. The WVP will beep twice

indicating that the “ON” command has been sent to the

WVC. It will beep twice again indicating the command

was successfully received by the WVC.

Tip: Use the retrieve program function (see page 14)

to identify if WVC has been turned off in the field. After

retrieving the program, a controller that has been turned off

will display the system off icon on the WVP display.

Programmable Rain Off

This feature permits the user to stop all programmed

waterings for a designated period from 1 to 7 days. At the

end of the programmable rain off period, the controller will

resume normal automatic operation.

1. Press the button until the

System Off icon and OFF is

displayed.

2. Press the button and a 1

will be displayed. The 1 will

be blinking at this point.

3. Press the button as many

times as needed to set the

number of days off desired (up to 7).

4. Squeeze the Transmit/Receive button once to move to

communication mode.

5. Use the and buttons to make sure the arrow is

pointed towards the WVC.

6. Squeeze and hold the Transmit/Receive button. The

WVP will beep twice indicating the command is being

sent to the WVC. It will beep twice again to indicate

that the WVC has received the command.

PROGRAMMING THE WVP (continued) ......................................................