SINCE 1886 R USE AND CARE GUIDE PLANK 4 LIGHT ISLAND PENDANT-#M99254
TOOLS REQUIRED Safety goggles Phillips screwdriver Flathead screwdriver Wire strippers Wire cutters Ladder Pliers Electrical tape NOTE: This pendant requires the use of four 120V, 60Hz, 60-Watt max, medium-base type G25 bulbs (included). Do not exceed the recommended wattage. HARDWARE INCLUDED NOTE: Hardware not shown to actual size.
Installation instructions 1. Preparing to hang light fixture □ Carefully unpack the fixture and lay out all parts on clean surface. □ Adjust the length of cord and support wires as desired by pushing or pulling the cord and support wires when pressing the knobs. 2. Installing the mounting plate CAUTION: Ensure the power is off at the main fuse box prior to beginning installation . □ Turn off the switch at the wall. □ Turn the power off at the main fuse box.
Installation instructions (continued) 4. 3. Connecting the wires □ Install the fixture green ground wire (1) under the ground screw (FF) on the mounting plate (BB). □ Connect the fixture green ground wire (1) to the green (or bare, or green & yellow) supply ground wire (2) in the outlet box using a wire nut (AA). □ Connect the white fixture wire (3) to the white (or ribbed) supply wire (4) in the outlet box using a wire nut (AA).