Use and Care Manual

Personal UltrasonicPersonal UltrasonicPersonal Ultrasonic
Model
20014-MW
20014-MB
READ AND SAVE THESE INSTRUCTIONS!
reach of children.
for any signs of damage. DO NOT use the product if the
cord has been damaged.
not in operation or while it is being cleaned.
This product is intended for residential use only. DO
NOT use outdoors.
Transducer
Fan exhaust
Adapter cap
Carrying bag
USB-C cord
Light on/off button
Mist adjustment
button
Mist exhaust
USB-C port
Reservoir
cover
Initial Setup:
1. Unravel and straighten the cord before use.
5. Connect the humidier to a power outlet using a USB-C
cord (included) and a USB power adapter rated DC 5V
2A (not included).
2.
4. Turn your water bottle upside down
and insert into the water reservoir.
Operation:
Maintenance:
DO NOT use water bottles greater than 22oz.
20308-01 20201112
1. To turn the humidier ON, press the
"MIST" button. This will adjust the mist
output to LOW (blue light), MEDIUM
(yellow light), HIGH (purple light) and
OFF. The indicator lights on the top of the unit will
indicate the humidity level selected.
NOTE: You may turn the LED light off by pressing the
"LIGHT" button while the humidier is still in operation.
2. To turn the humidier OFF, press the "LIGHT" button to
make sure the LED light is ON, then press the "Mist"
button until the indicator lights turn off.
1.
humidier and unplug the power adapter from the wall.
2.
Remove the water bottle from the unit and remove the
adapter cap.
3.
Empty the water from the bottle.
4.
Replace the water bottle if necessary.
5.
empty any remaining water.
6.
Wipe any mineral deposits from the cover and base
with a soft cloth.
7.
Replace the cover onto the base. Align
the notch on the cover with the groove
on the base. The mist exhaust should
be 45
O
to the right of the control
buttons.
Failure to ensure the adapter cap is seated correctly may
cause the unit to leak water from the water bottle.
Turn off the humidier, disconnect the USB-C cord from the
Rinse the adapter cap thoroughly with warm water.
3.
Use the adapter cap that came with
your humidier and press it down over
the mouth of the water bottle rmly.
NOTE: This humidier works at LOW
mist setting only if connecting to lower
rating USB power adapter.
NOTE: If you are using other USB-C
cord, please make sure it is less than 33" in length. The
mist level may be affected if using longer USB-C cords.