Instructions / Assembly

ManualsBrandsHunter ManualsElectrical100W Equivalent Soft White (2700K) GU24 CFL Light Bulb

9943520 REV. D KG JUN03 8A000

1. Remove the cover from fan by removing two

brass 8-32 screws and save these screws for re-

attaching cover. Remove plastic wire nuts from

switch housing wires and strip 1/2" insulation from

both wires (black or blue, and white). Remove the

center plug from the cover. See FIG. 1

NOTE: If installing this light fixture on a 3

Speed pull-chain model fan, a separate pull-

chain switch (included with the fan) must be

installed. Refer to the following installation

instructions, otherwise skip to step 4.

2. Remove the plastic plug from the fan switch

housing. Install the light on-off switch by inserting

the chain through hole, from the inside. Pass the

switch threads into the hole and screw the knurl nut

onto the switch. Hand tighten firmly. See FIG. 2

3. Attach the blue wire from the fan to one of the

blue wires on the switch by twisting the bare ends

of the wires together. Secure the splice by thread-

ing on one of the wire nuts provided. Test the

secureness of the splice by pulling on the wire nut.

Fixture Light Bulb(s) Dimensions (w/glass) Weight

K4C 4 - 60w A15 med base 9"h x 23"w 2 lbs

K1K 1 - 100w A19 med base 7"h x 9"w 3 lbs

K2K 1 - 100w A19 med base 6"h x 6"w 3 lbs

WARNING: To reduce the possibility of electrical shock, be sure that the power is turned off at its source

(fuse or circuit breaker). All electrical components must be installed in accordance with national and local

electrical codes. To reduce the risk of fire and electrical shock, this light fixture should be used only with

UL, ETL & CUL Certified Casablanca ceiling fans.

READ AND SAVE THESE INSTRUCTIONS

INSTRUCTIONS FOR MOUNTING THESE CENTER STEM

LIGHT FIXTURE: K1K, K2K, K4C

IMPORTANT: Before discarding any packing material locate the following items:

FIG. 1

SWITCH

HOUSING

COVER

CENTER PLUG

8-32 SCREW

WIRE NUT

PULL-CHAIN

SWITCH

KNURL NUT

WHITE WIRE

PLASTIC PLUG

BLUE WIRE

FIG. 2

INSTALLATION

Summary of content (2 pages)

PAGE 1
READ AND SAVE THESE INSTRUCTIONS INSTRUCTIONS FOR MOUNTING THESE CENTER STEM LIGHT FIXTURE: K1K, K2K, K4C WARNING: To reduce the possibility of electrical shock, be sure that the power is turned off at its source (fuse or circuit breaker). All electrical components must be installed in accordance with national and local electrical codes. To reduce the risk of fire and electrical shock, this light fixture should be used only with UL, ETL & CUL Certified Casablanca ceiling fans.
PAGE 2
4. Guide the two wires from the light fixture through the center plug-hole in cover and then thread the light fixture into the center hole. Hand tighten firmly. See FIG. 3 5. While holding light fixture up to the fan, attach the wires from the fan switch housing and the wires from the light fixture together (black-to-black or blue-to-black and white-to-white) by twisting the bare ends of the wires together. Then secure the splices by threading on the wire nuts provided.