Owner manual

15 AMP SDLID-STATE SPEED CONTROL MODEL E2394
FOR USE WITH AS MANY AS SIX 52' or TEN 42' LISTED WUNTCR SUSPENDED CEILING FANS.
CAUTION:
ALL WIRING MUST BE PERFORMED IN ACCORDANCE WITH
NATIONAL AND LOCAL ELECTRICAL CODES. WE RECOMMEND
INSTALLATION BY A QUALIFIED ELECTRICIAN. DISCONNECT
POWER TO CEILING FANS AT THE MAIN ELECTRIC PANEL
PRIOR TO INSTALLATION.
READ AND SAVE THESE
INSTRUCTIONS
VIRE NUT
MOTOR LINE
CAUTION-RISK OF
ELECTRICAL SHOCK
MINIMUM 2* DEEP
va;_l switch box
POWER LINE
115 VOLTS
60 CYCLE
FACE PLATE
IF 4 VIRES ARE SEEN IN
WALL BOX CONNECT EACH
SPEED CONTROL LEAD TO A
BLACK VIRE. SEE FIGURE.
IF 2 VIRES ARE SEEN,
CONNECT EACH TO A SPEED
CONTROL LEAD. USE VIRE
NUTS SUPPLIED.
SPEED CONTROL-
KNOB
NDTL' USE OF A LIGHT KIT WITH ANY CEILING FAN DECREASES THE MAXIMUM NUMBER
□ F FANS THAT MAY BE SAFELY USED WITH THIS CONTROL. ADD UP THE' TOTAL
WATTAGE OF LIGHT BULBS BEING USED, DIVIDE BY 120, AND SUBTRACT THIS
RESULTANT LINE CURRENT FROM 15 AMPS. WHATEVER IS LEFT IS THE MAXIMUM
CURRENT THAT THE TOTAL NUMBER OF CEILING FANS CAN DRAW. FOR SAFETY,
CONSIDER THAT EACH 52' FAN MOTOR DRAWS 1.0 AMPS AND EACH 42' FAN
DRAWS 0.6 AMPS or LINE CURRENT.
> f I • c « t • « •
}iOO fAttCO AVtMUC
WPHIt TK I > 4
(¿) MUHTIR RAN COMRAHY
FGRM 4073.0
B.F #1306 A400.'? 3
} 0