User Manual

Hunter Fan Company 42704-01 • 01/29/07

Motor

Housing

Hanger

Pipe

Wires

Motor Housing

Set Screw

Canopy

CAUTION

BE SURE TO TIGHTEN THE HANGER PIPE INTO THE FAN, AND THE

HANGER BRACKET ONTO THE PIPE. TIGHTEN THE 2 SET SCREWS, AS

DESCRIBED IN STEP 7, TO PREVENT THE FAN FROM FALLING. YOUR FAN

MAY WEIGH UP TO 50 LBS. ALL OF THE FOLLOWING STEPS MUST BE

FOLLOWED IN ORDER TO ENSURE A SECURE MOUNTING.

! !

Hanging The Fan

1. Feed the wires from the top of your motor through the hanger pipe (see Fig. 3).

2. Back out the motor housing set screw (Do not completely remove from fan) in neck of fan motor

housing and hanger bracket assembly so the hanger pipe can be screwed in.

3. Screw the pipe into the fan until tight (at least 4 1/2 turns) (see Fig. 4).

NOTE: Some of the pipe threads may still be visible.

4. Slide the canopy down over the hanging pipe (see Fig. 5).

Fig. 3

Fig. 4

Fig. 5