Installation Guide

Hunter Fan Company 41532-01 • 02/11/15
9
CAUTION
BE CERTAIN THAT THE ELECTRICITY IS TURNED OFF AT THE
MAIN PANEL BEFORE STARTING THIS SECTION.
! !
CAUTION
NO BARE WIRES OR WIRE STRANDS SHOULD
BE VISIBLE AFTER MAKING CONNECTIONS.
! !
Wiring the Fan
Wall switches are not included. Select an
acceptable general-use switch in accordance with
national and local electrical codes.
1. Before attempting installation, make sure the
power is still off.
2. To connect the wires, use the wire connectors
provided in the hardware bag. Hold the
bare metal leads together and place a wire
connector over them, then twist clockwise
until tight.
3. Connect the bare or green ground wire
(grounding) from the ceiling to the side of the
hanger bracket assembly.
4. Connect the white wire (grounded) from the
ceiling to the white wire (grounded) from the
fan.
5. Connect the remaining wires as follows for
either Dual or Single Switch Wiring:
For Dual Switch Wiring (see Fig. 8):
• e black wire (ungrounded) from the ceiling
to the black wire (ungrounded) from the fan.
• e blue wire (ungrounded) from the fan to
the wire (ungrounded) from the wall switch.
For Single Switch Wiring (see Fig. 9):
• The black wire (ungrounded) from the ceiling
to the black (ungrounded) and the blue wire
(ungrounded) from the fan.
Fig. 8
6. Turn the splices upward and push them
carefully into the outlet box.
7. Spread the wires apart, with the grounded
wires on one side of the outlet box and the
ungrounded wires on the other side of the
outlet box.
Wire Connector
Fig. 9
NOTE: All wiring must be in accordance with national and
local electrical codes and ANSI/NFPA 70-1999. If you are
unfamiliar with wiring, use a qualified electrician.
Ground
Wire
Ground
Wire