Hunter Outdoor Light Fixture Installation Instructions 41370-01 7/28/2005 41370-01 rev 7-28-05.
CAUTIONS • • Read all installation instructions carefully before beginning installation and save these instructions. To reduce the risk of electrical shock and/or fire, install this light fixture only on HunterTM type 5 fans marked suitable for use in wet locations, when installed in a GFCI protected branch circuit. Note: e fan type can be found on the ceiling fan package and on the name plate label located on top of the motor housing of the ceiling fan.
Steps 1. Disconnect power to the ceiling fan by turning off the circuit breakers to both the outlet box and to its associated wall switch location. 2. Remove the lower switch housing from the fan and remove the cover. (see figure 1) 3. Locate the black wire with a white stripe and the white wire in the lower switch housing.
8. Place the two louver rings over the globe and align the four holes in the rings with the four holes in the globe. read two screws through to keep the holes aligned. (see figure 4) 9. Align the notch in the upper louver ring with the pull chain switch on the light kit. Align two screws with two of the four holes in the light kit rim. (see figure 5) 10. Securely install the two threaded screws, followed by the two remaining screws. (see figure 6) 11. Restore power to the ceiling fan.
Troubleshooting Light does not come on. 1. Pull light pull chain one or two times to see if light comes on. 2. Make sure the bulb is installed properly and filament is not blown. 3. Make sure breakers or fuses are on. 4. Verify that the light power lead is connected at the ceiling. Refer to your ceiling fan manual for locating, assembly and wiring. Globe rattles. 1. Make sure the globe is secure. 2. Tighten all screws.
Hunter Fan Company 2500 Frisco Avenue Memphis, Tennessee 38114 is Light Fixture weighs 1.9 lbs. 41370-01 rev 7-28-05.