Instruction Manual

4
43552-01 • 04/15/14 • Hunter Fan Company
1 • Installing the Light Kit on Fans With Removable Switch Housings
Removable Switch Housing
9-Pin Plug
Connector
Lower Switch
Housing
Plug Button
Screw
Steps 1-2
Washer
Wires
Threaded
Rod
Nut
Steps 6-7
Light Kit
Fitter
Switch
Housing
#6-32
Screw
Steps 3-5
1. Unscrew the three screws from the upper switch housing. Disconnect the
9-pin plug connectors. Remove the lower switch housing.
2. Push the plug button from inside the lower switch housing to remove the
plug button and switch housing cap.
NOTE: Save the plug button and switch housing cap should you choose to
remove the light fixture in the future.
3. To attach the light kit, partially install two #6-32 screws and the lock washers
on the red tag into the switch housing.
4. Align the keyhole slots in the light kit with the #6-32 screws.
5. Turn the mounting plate counterclockwise until the housing assembly screws
are firmly situated in the narrow end of the keyhole slots. Tighten screws
firmly.
6. Feed the two wires from the light kit through the center hole in the lower
switch housing.
7. To secure the light kit fitter, thread the nut and washer onto the rod from the
light kit. Tighten the nut and washer you previously threaded onto the rod
from the light kit.
8. Remove the wire connectors from the two wires in the switch housing
labeled “Connect Light Here” or “For Light Use.” To connect the wires, hold
the bare metal leads together and place a wire connector over them, then
twist the wire connector clockwise until tight.Connect the black wire with
a white stripe from the switch housing to the black wire from the light kit.
Connect the white wire from the switch housing to the white wire from the
light kit. Secure all wire connections using wire connectors.
CAUTION: Be sure no bare metal wires or wire strands are visible after
making the connections.
9. Go to the instructions for installing the bulbs and globe.
WARNING: Improper
installation could
cause the light fixture
to fall.