Hunter Outdoor Light Fixture Installation Instructions 41770-01 05/16/2005 41770-01.
• • • • • CAUTIONS Read entire installation instructions carefully before beginning installation and save these instructions. To reduce the risk of electrical shock, install this light fixture only on HunterTM fan type 5. Marked suitable for use in wet locations when installed in a GFCI protected branch circuit. Note: e fan type can be found on the ceiling fan package or on the name plate label located on top of the motor housing of the ceiling fan.
1. Disconnect power to the ceiling fan by turning off the circuit breakers both to the outlet box and to its associated wall switch location. 2. Align the three holes in the gasket with the three holes in the switch housing mounting plate. Partially install two screws. 3. Place the keyhole slots in the upper rain shield over the two partially installed screws and turn the upper rain shield counter clockwise. 4.
9. Connect the 9-pin plug connectors. Attach the lower switch housing to the upper switch housing with the three thumb screws. 10. Attach the lower rain shield to the upper rain shield with four screws. Securely tighten all four screws. 11. Attach the wire cage to the lower rain shield with four screws. Securely tighen all four screws. 12. Install a 75 W Max A-19 bulb. 13. Raise the glass globe and align the indents in the glass globe with the tabs on the fitter. Twist the glass globe clockwise to secure.
41770-01.
Hunter Fan Company 2500 Frisco Avenue Memphis, Tennessee 38114 is Light Fixture weighs 7.0 lbs. 41770-01.
