Instructions / Assembly

6
Step 3-1
Step 3-2 - 3-3
Rubber
Gasket
Rubber
Gasket
Upper
Canopy
Lower
Canopy
Pipe
Decorative
Sleeve
Metal
Gasket
3 • Assembling and Hanging the Fan
Hunter® Fan Company 43113-01 • 04/13/07
Adaptor
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
Standard Mounting - 9’ ceilings or higher:
• reading the wires through the adapter, screw the adapter onto
the shaft on the top of the fan and securely tighten the upper
setscrew with the included allen wrench.
• Loosen the lower setscrew in the adapter. reading the wires
through the 7” pipe, screw the pipe into the adapter on top of the
fan and securely tighten the upper setscrew.
CAUTION: e adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
• Slide the lower canopy onto the pipe with the large opening
facing the fan.
• Slide the metal gasket and decorative sleeve onto the pipe (in that
order). Orient the gaskets so that the sleeve will overlap the lip of
each gasket.
• Slide the upper canopy onto the pipe with the large opening
facing away from the fan. en slide the rubber gasket onto the
pipe, oriented so that the lip slides into the sleeve. Continue to
step 3-1.
Low Profile Mounting - 8’ - 9’ ceilings:
Note: For Low Profile Mounting, Adapter is not used.
• reading the wires through the 2.75” pipe, screw the pipe into
the top of the fan and securely tighten the setscrew.
• Slide the lower canopy onto the pipe with the large opening
facing the ceiling, the upper canopy is not used for low profile
mounting.
3-1. Screw the hanger bracket onto the top of the pipe at least three
full turns. Securely tighten the setscrew on the hanger bracket.
3-2. Center the pin in the rubber bushing.
3-3. Holding the fan by both the motor housing and the pipe, lift the
fan assembly and hook both sides of the hanger bracket onto the
bushing pin assembly.