Personal Space Air Cleaner SOLO2 Owner’s Guide English MODELS 30030, 30031, 30033, 30034 Form# 43057-01 20100609 ©2010 Hunter Fan Co. ©2008 Hunter Fan Co.
Table of Contents 4. DO NOT immerse the SOLO2 in water at any time because permanent damage will occur. To properly clean your SOLO2, follow the instructions in the Maintenance section of this manual (page. 4). Safety Instructions..................................................................2 Introduction.............................................................................2 5.
Air Filtration System Solo2 Components How the HEPAtech® System Works FILTER CHECK (AMBER LED) Air is pulled in through the bottom of the unit where particles such as dust, dander, and pollen collect on the HEPAtech® filter, leaving the air emitted from the front of the SOLO2 cleaner and healthier for your personal space. Figure 1. The carbon pre-filter on the back of the filter also helps to eliminate odors from the air.
Operation To turn your SOLO2 unit on, press the up and down touch pads on the unit simultaniously. Once on, press the up or down arrow buttons to adjust fan speed. To turn your SOLO2 unit back off, press both touch pads on the front of the unit again. Figure 3. There are ten fan speeds on your Solo2 unit. Once set, your SOLO2 unit will remember your last setting when it is turned back on. NOTE: When using the touch panel on the front of the SOLO2, you must use your fingertips to operate the controls.
Changing the Filter 1. To change the filter in your SOLO2, turn the unit off and unplug the power cord. Hinge Guide 2. Turn the SOLO2 on it’s side and remove the wire base from the bottom of the unit by compressing the hinges on either side of the wire base (a) and gently pulling each out of the bottom of the SOLO2 unit (b) . Figure 5. a. Pinch b. Pull to remove Bumps Figure 7. 5. Align the bumps on the hinges on the wire base with the holes on the bottom of the unit and snap into place.
Troubleshooting Warranty Hunter Fan Company SOLO2 Air Cleaner System 5 YEAR LIMITED WARRANTY 1. I cannot operate SOLO2 from the controls on the product. Unplug the power adapter from the wall and allow it to set for one minute. Plug the power adapter back into the wall and press the up and down arrows on the front of the unit at the same time to turn it on.
LIMITATION MAY NOT APPLY TO YOU. This warranty excludes and does not cover defects, malfunctions or failures of the Air Cleaner which were caused by repairs by persons not authorized by us, use of parts or accessories not authorized by us, mishandling, modifications, or damage to the Air Cleaner while in your possession, or unreasonable use, including failure to provide reasonable and necessary maintenance. This warranty does not cover Air Cleaners used in commercial applications.
©2010 Hunter Fan Co.