Total Air Sanitizer Owner’s Manual English Models 30890 30891 30892 30895 30405 30406 30407 30441 44068-01 20111111 ©2011 Hunter Fan Co.
Table of Contents I At A Glance II Using Your Total Air Sanitizer Introductions and Warnings...................................3 Initial Setup and Operation....................................4 How it Works........................................................5 III Maintenance Replacing the Filter................................................6 IV Air Sanitizer Assistance Troubleshooting and Support.................................7 Log............................................................
At A Glance Introductions and Warnings I Congratulations! You’ve purchased one of the most advanced products available on the market today to improve indoor air quality. The Hunter Total Air Sanitizer captures most airborne pathogens “germs, viruses, mold, and mildew” that enter the system. Hunter’s patented technology then kills virtually everything that has been captured within 24 hours of entering the system.
Using Your Total Air Sanitizer II Initial Setup and Operation 1. Take the Total Air Sanitizer out of the box and remove the clear plastic protective bag and place the unit on a firm, level surface. 2. Before turning on the Total Air Sanitizer, you need to confirm that the filter tis firmly in place and has not become loose during shipping. To release the door, push down on the Hunter® logo on the door to release the front grill. Figure 1. Figure 1 3.
Using Your Total Air Sanitizer How it Works II Dust and other irritants are pulled into the Air Sanitizer by the fan. The energized HEPA® filter attracts particles like pet dander, hair, and mold, and traps them. Virtually all of the particles can be captured and killed within 24 hours by the energized HEPA® filter.
Maintenance III Replacing the Filter About every 6 months you should check your filter to see if it needs to be replaced. Heavy build-up on the filter can cause the energized field on the filter to not operate properly. 1. Turn the air sanitizer off and unplug it from the wall outlet. WARNING: Wait 10 seconds before opening the panel. 2. Push down on the Hunter logo to release the door. Figure 6. Figure 6 3. Gently pull the door away from the unit and lift away. Figure 7. 4.
Air Sanitizer Assistance Troubleshooting and Support 1. Unit does not operate. • Confirm that the unit is plugged in. • Check the installation of the filter. 2. Unusual noise; popping, sizzling, etc. • Reset the Total Air Sanitizer. Unplug the unit for 1 minute, then plug it back in. • Check the installation of the filter. • Check to see if the filter needs to be replaced. 3. Unit has reduced air flow or increased noise. • The Filter may be excessively dirty. Replace the filter if needed.
Air Sanitizer Assistance Log Notes 8 IV Filter Log 44068-01 • 11/11/2011
Warranty V 5 Year Guarantee The Hunter Fan Company makes the following limited warranty to the original residential user or consumer purchaser of the HEPA® Total Air Purification System: If any part of your Total Air Sanitizer motor fails during the first five (5) years from the date of installation due to a defect in material or workmanship, we will provide a replacement Air Sanitizer free of charge. Installation is deemed to occur at the date of purchase.
Warranty V 5 Year Guarantee y nt ra ar W Goodlett Farms Pkwy., Suite 400, Memphis, Tennessee 38016, 1-888-830-1326. For the name of our nearest authorized Hunter Fan Company Service Center, write to the Hunter Fan Company at the preceding address. You will be responsible for insurance and freight or other transportation to our factory service center. We will return the Total Air Sanitizer freight prepaid.
