Installation Guide

8
1886
1886
Blade Arm Screw
Ceiling Bracket Hanging Fan Wiring Installing Fan Body Blades Light Remote App
Installing the Bulbs and Glass
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
Assembling the LIght Kit
Notch
Tab
Insert the third light kit screw,
found in the hardware bag,
into place and then tighten all
three screws.
Install the third light kit screw and
tighten all three screws securely.
Partially install two light kit screws,
found in the hardware bag,
halfway into the light kit assembly
plate as shown. It does not matter
which two screw holes you
choose.
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
2 of 6
Light Kit Screw
bag
1 of 6
Light Kit Screw
bag
1 of 6
Light Kit Screw
bag
2 of 6
Light Kit Screw
bag
Make sure all the wires from the fan and the
light kit are snug inside the center of the light
kit, not pinched in between the upper switch
housing and the light kit or hanging out of the
sides. Turn the light kit counterclockwise until
the light kit screws are rmly situated in the
narrow end of the keyhole slots.
Partially install two of the light kit
screws found in the bag. It
does not matter which two screw
holes you choose. Connect the plugs
from the upper and lower switch
housings.
Fan style may vary.
Note: