Use and Care Manual

7
1886
1886
Installing the Cap
Installing the Switch Housing
ON
Turn Power
Raise the bottom cap to the switch housing. Align
the screw holes in the switch housing and the screw
holes in the bottom cap.
Insert the housing screws found in the hardware bag
Installing Wall Control
3 of 3
1 of 32 of 3
Lower Switch
Housing Screw
Upper Switch
Housing Screw
Upper Switch
Housing Screw
bag
bagbag
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Switch HousingBlades Wall Control
Screw two (2) housing assembly screws from the
hardware bag halfway into the motor housing. It
does not matter which two screw holes you choose.
Feed the wire plug through the center hole
of the upper switch housing, then wrap
keyhole slots around the screws and twist
counterclockwise.
Insert the third screw, found in the hardware
bag, into place and then tighten all three (3) screws.
WARNING
FAN FALL HAZARD
Make sure screws are tight to secure the upper
switch housing to the mounting plate.