Full Product Manual

7
8
1886
1886
Ceiling Bracket Top housing Hanging Fan Wiring Canopy Blades Light Glass/Bulbs
Assembling the LIght Kit
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
3 of 9
Light Kit Screw
bag
1 of 9
Light Kit Screw
bag
3 of 9
Light Kit Screw
bag
Attach the hood to the upper switch
housing using three light kit screws
found in the hardware bag.
Attach the lower switch housing to the hood
assembly using three light kit screws found
in the hardware bag.
Partially install two light kit
screws, found in the
hardware bag, halfway into
the adapter plate as shown.
It does not matter which two
screw holes you choose.
1 of 9
Light Kit Screw
bag
Feed the wire plug through the center hole of
the hood assembly. Align the keyhole slots in
the hood assembly with the two screws you
just installed. Lift the hood assembly so that
the keyhole slots engage the two screws,
and twist counterclockwise to lock the hood
assembly into place.
Connect the plug to the lower
switch housing. Make sure to
line up the colored markings
on the connectors and that the
connectors latch.
Install the bulb into the socket.
When necessary, replace with
bulb of the same wattage.
ON
Turn Power
Insert the third screw found in
the hardware bag, into place
and then tighten all three screws.