Use and Care Manual

8
1886
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Bulbs/Glass Remote CradleRemote
Installing the Glass
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Install the included LED
bulbs into the sockets.
When necessary, replace
with bulbs of same wattage.
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Notch
Tab
Assembling the Light Kit
Insert the third screw,
found in the hardware
bag, into place and then
tighten all three screws.
Screw two light kit screws
from the hardware bag
halfway into the motor housing.
It does not matter which two
screw holes you choose.
Feed the wire plug through the
center hole of the upper switch
housing, then wrap keyhole
slots around the screws and
twist counterclockwise.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
Partially install two of the light kit screws
found in the bag. It does not matter
which two screw holes you choose. Connect
the plugs from the upper and lower switch
housings. Make sure to line up the colored
markings on the connectors.
Lift and align the keyhole slots in the
light kit housing with the two screws.
Make sure all the wires from the fan
and the light kit are snug inside the
center of the light kit, not pinched in
between the upper switch housing and
the light kit or hanging out of the sides.
Turn the light kit counterclockwise until the
switch housing screws are rmly situated in the
narrow end of the keyhole slots. Install the third
screw and tighten all three screws securely.
1
STEP
4
STEP
1
STEP
2
STEP
3
STEP
2
STEP
5
STEP
3
STEP
6
STEP
Blade Arm Screw
2 of 6
Light Kit Screw
bag
1 of 6
Light Kit Screw
bag
1 of 6
Light Kit Screw
bag
1 of 6
Light Kit Screw
bag