Owner's Manual

INSTALLATION

CEILING BRACKET

• CAUTION: Do not install the fan from a single structure such as a purlin, truss, I-beam or bar joist.

• For any questions or concerns regarding the building structure, consult a structural engineer.

To prevent SERIOUS INJURY or DEATH, ALWAYS mount fan directly from building structure or outlet box marked acceptable for fan support

of 70 lbs (31.8 kg).

CRUSH HAZARD

For angled ceilings,

point opening

toward peak.

ANGLED

MOUNTING TIP

Remove any existing bracket prior to installation. Only use the provided Hunter ceiling bracket that came in your fan’s box.

If you are unable to do this,

call Technical Department at

1-844-593-FANS(3267) for guidance.

OFF

Turn Power

Do this rst!

Use machine screws

(provided with outlet box)

and washers when securing

to existing ceiling fan-rated

outlet box. Make sure it is

securely installed and is

acceptable for fan support of

31.8 kg (70 lbs) or less.

Machine Screws

WARNING

To avoid possible electrical shock, before

installing your fan, disconnect the power by

turning off the circuit breakers to the outlet

box associated with the wall switch location.

Remove the four screws

from the restraining bracket

and set aside. Remove the

restraining bracket from

the hanging bracket (H) and

set aside.