Owner's Manual

14
INSTALLATION
DOWNROD
3
A
D
A
Place the preassembled
downrod (E) through the
canopy(I) and upper motor
housing (J).
C
Connect the communication
cable from the downrod to the
fan. Connect the power cable
from the downrod to the fan.
(*240V will have a different
power cable port)
B
Place the bottom of the downrod
into the bracket of the fan while
aligning the holes. Make sure power
cable and communication cable are
facing the power and data ports to
ensure a connection.Place a bolt
through each hole and secure each
bolt with a nut.
E
F
E
I
J
D
Attached the secondary hanging
cable to the fan by threading the
cable eye through the upper slot
of the motor shaft. Attach the
D-shackle to the wire as shown and
secure by screwing the pin through
unthreaded wall of shackle and the
cable eye into the threaded wall of
shackle until it is tight.
C
F
J
Power Cable
Communication Cable
B
E
F
x2
I
J
Large End
*For 240 V models the power cable
will need to attach to module (A)
A
Motor Shaft
Upper Slot
WARNING
FAN FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure bolts are securely tightened and shackle
is secure.