Owner's Manual

15
A
Lower the upper motor
housing (J) and twist
clockwise to secure.
Ensure the fan is sealed
by eliminating any gap
between the housing
and fan.
INSTALLATION
MOTOR ASSEMBLY
4
CRUSH HAZARD. To prevent serious injury or death, ALWAYS attach the
Retention Cable to the fan motor and secure to the building structure
on EVERY fan.
C
A
D
B
Place hanger guide (M) through the
back of the hanger bracket (H) until
the back of the guide and bracket
are ush. It should snap into place
when correctly installed.
C
Lift motor assembly and insert hanger
ball into hanger bracket (H), guiding the
hanger ball tabs along the hanger guide
rails until the hanger ball is secure. The
hanger groove should be in between both
hanger ball tabs. REMOVE HANGER
GUIDE FROM BRACKET by squeezing
ends together and sliding away from
bracket.
D
To secure the motor assembly
take the restraining bracket and
place over the ceiling bracket and
align the holes. Insert and secure a
screw into each hole.
F
E
E
E
E
H
H
H
J
Hanger Guide Rails
Hanger Groove
Hanger
Ball Tabs
B
M
H