Owner's Manual

BEFORE YOU BEGIN

SAFETY & PRECAUTIONS

To prevent serious injury or death:

• BEFORE installing or servicing your fan, ALWAYS disconnect the power by turning off the circuit breaker or breakers, to the

fan locations and conrm Lockout/Tagout procedures are in place. If you cannot lock the circuit breakers in the off position,

securely fasten a prominent warning device, such as a tag, to the electrical panel.

• All wiring must be in accordance with national and local electrical codes, including ANSI/NFPA 70. If you are unfamiliar with

wiring or are in doubt, consult a qualied electrician.

• Do not use extension cord with fan.

• Do not remove covers while power is on.

• Do not use improper voltage source.

All fan controls and incoming power should be installed only by qualied technicians familiar with the requirements of the National Electrical Code

and local codes. Failure to follow these guidelines will void the manufacturer’s warranty.

All electrical controls are congured at the factory and are ready to use. No user adjustments are available. Follow the included installation

instructions when installing this device to ensure proper operation. Do not make any changes to any part of the fan without rst consulting Hunter

Industrial Fan. Installation is to be in accordance with ANSI/NFPA 70: National Electrical Code and local codes.

The user is responsible for compliance with all international and National Electrical Code requirements with respect to grounding of all equipment.

Many of the parts of this unit operate at line voltage.

Before installing, servicing or cleaning the unit, switch power off at the service panel, lock the service disconnecting means and conrm Lockout/

Tagout procedures are in place to prevent power from being switched on accidentally. When the service disconnect means cannot be locked,

securely fasten a prominent warning sign, such as a tag, to the service panel.

To reduce the risk of electric shock, serious injury and death, only use this unit as intended by the manufacturer. If you have any questions, call

our Technical Department at 1-844-593-FANS (3267).

Electric Shock Hazard