Use and Care Manual

FUSED PLUG
5
Figure 3
Figure 4
Figure 5
61901-01 R20180517
This product employs overload protection
(fuse). A blown fuse indicates an overload
or short-circuit situation. If the fuse blows,
unplug the product from the outlet.
Replace the fuse as per the user servicing
instructions (follow product marking for
proper fuse rating) and check the product.
If the replacement fuse blows, a
short-circuit may be present and the
product should be discarded or returned
to an authorized service facility for
examination and/or repair.
USER SERVICING INSTRUCTIONS:
1.
2. Slide the door on top of the plug
3. Carefully remove the fuse from
the clips holding it on the top and
Warning! Electrical Hazard! Only
replace with a fuse type and rating
matching what was removed from the
product. If the product fails a second time,
immediately unplug it and contact our
technical support at 1-888-880-3267.
4. Gently push the fuse back into
the pins that will hold it in place.
Note: If the fuse is not seated properly,
the unit will not function.
5.
box in the plug.
6. Plug the fan back in and resume
use.
Grasp plug and remove from the
receptacle or other outlet device.
Do not unplug by pulling on cord.
Locate the door on top of the plug.
Figure 3.
Risk of fire. Do not replace attachment
plug. Contains a safety device (fuse) that
should not be removed. Discard product
if the attachment plug is damaged.
bottom. Risk of fire. Replace fuse
only with 5 Amp, 125 Volt fuse.
Figure 5.
Slide the door back over the fuse
towards the blades. Figure 4.