7" Personal Fan Owner’s Manual English Models 90409 90410 90411 90412 90413 90418 90420 90425 61905-01 R20170320
IMPORTANT SAFETY INFORMATION READ & SAVE THESE INSTRUCTIONS! WARNING 11. Do not operate any fan with a damaged cord or plug. Discard fan or return to an authorized service facility for examination and/or repair. shock, DO NOT use this fan with any solid-state speed control device. 12. To disconnect, grip plug and pull from wall outlet. NEVER yank on cord. CAUTION When using electrical appliances, basic precautions should always 13. ALWAYS use on a dry surface. 14.
WELCOME UNPACKING Thank you for choosing the Hunter 7" Yoke Fan. This manual gives you complete instructions for using your fan. Here are some the features you will enjoy with your fan: As you unpack the fan, save the carton and packing materials in case you want to move or ship the unit in the future. Carefully remove all items from the box. NOTE: It is best to have someone hold the box while you lift the fan and the protective packaging out of the carton.
GROUNDING INSTRUCTIONS This appliance is for household use only and may be plugged into any 120-volt AC electrical outlet (ordinary household current). DO NOT use any other type of outlet. LINE CORD SAFETY TIPS 1. NEVER pull or yank on the cord or the appliance. 2. and guide it into the outlet. WARNING 3. To disconnect the appliance, grasp the plug and remove it from the outlet. This unit is suitable for grounded receptacle use only. 4.
FUSED PLUG This product employs overload protection (fuse). A blown fuse indicates an overload or short-circuit situation. If the fuse blows, unplug the product from the outlet. Replace the fuse as per the user servicing instructions (follow product marking for proper fuse rating) and check the product. If the replacement fuse blows, a short-circuit may be present and the product should be discarded or returned to an authorized service facility for examination and/or repair.
OPERATION 4. To select the speed, turn the Power/Speed Switch from OFF to the desired speed setting: I (low), O (off), II (high). This appliance is for household use only. 1. surface where it cannot fall or be pulled by the cord. 5. To control the upward and 2. Plug the fan into a grounded 120-volt AC electrical outlet (ordinary household current). DO NOT use any other type of outlet. Make sure that the rated voltage of the fan is the same as the power source before plugging it into the power source.
MAINTENANCE This fan is permanently lubricated and will not require additional lubrication (oil) for the life of the fan. This fan requires little maintenance and contains no user serviceable parts. DO NOT try to repair it yourself. Contact if servicing is needed. 3. DO NOT immerse the fan in water or any other liquid. 4. Use a dry or slightly damp lint free cloth to clean the fan. 5. DO NOT allow water or any other liquid to get into the motor housing or base. 6.
STORAGE TROUBLESHOOTING 1. Disassemble and clean fan before storing. PROBLEM 2. Keep the original packaging for the purpose of storing the fan. SOLUTION 3. ALWAYS store the fan in a dry place. Loosen the tilt knobs on the side of the fan. Adjust to the desired angle and tighten the screw. 4. NEVER store the fan while it is still plugged in. TECHNICAL SUPPORT 5. NEVER wrap the cord tightly around the fan.
WARRANTY OR FITNESS FOR A PARTICULAR PURPOSE, ARE VOIDED. NO WARRANTY, EXPRESSED OR IMPLIED, INCLUDING ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS MADE IN RESPECT TO THE GLASS GLOBES OR LIGHT BULBS OR THE FINISH ON ANY METAL PORTION OF THE FAN. THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES.
To obtain servicing, contact the nearest Hunter authorized service center or the Hunter Home Comfort Service Department, 1831-A West Oak Parkway, Marietta, GA 30062. Please contact us before shipping your fan to us. If we authorize you to ship it to us, you will be responsible for all insurance and freight or other transportation charges to our factory service center. We will return your Hunter Fan freight prepaid.
