Instructions / Assembly

MA015-01 • 12/31/13
1.888.830.1326
Improper installation could cause the light xture to
fall, or result in electrical shock or personal injury.
If your fan does not have pin connectors on the
wires coming from the switch housing, install
the wiring harness provided. Using the provided
wire connectors connect the white wire from
the fan to the white wire from the wire harness
and connect the black or blue wire from the fan
to the black wire from the wire harness.
Lift the light kit up to meet the upper
switch housing. Install the switch housing
assembly screws. Tighten screws.
Using the single pin connectors, connect the
black or blue wire from the fan to the black
wire from the light kit. Connect the white
wire from the fan to the white wire from the
light kit.
Note: Do not allow the light kit to hang only
by the wire connectors.
If your fan does not have pin connectors on the
wires coming from the switch housing, install
the wiring harness provided. Using the provided
wire connectors connect the white wire from
the fan to the white wire from the wire harness
and connect the black or blue wire from the fan
to the black wire from the wire harness.
Wire
Connector
Switch Housing
Assembly Screw
Switch
Housing
Using the single pin connectors, connect the
black or blue wire from the fan to the black
wire from the light kit. Connect the white
wire from the fan to the white wire from the
light kit.
Note: Do not allow the light kit to hang only
by the wire connectors.
Lift the light kit up to meet the lower switch
housing. Guide the two pre-installed light
kit screws into the holes in the lower switch
housing. Tighten screws.
Read entire installation instructions
carefully before beginning installation
and save these instructions.
If your fan’s switch housing cap
resembles this one, remove the
whole switch housing by removing
the switch housing screws with a
Phillips head screwdriver. Remove
the plug button. Then follow the
TYPE-B ASSEMBLY INSTRUCTIONS.
If your fan’s switch housing cap
resembles this one, remove the
cap screws with a Phillips head
screwdriver. Then follow the
instructions for TYPE-A ASSEMBLY.
Switch
Housing
Cap
Cap
Screw
TYPE-A ASSEMBLY
WHICH ASSEMBLY
METHOD WILL I USE?
TYPE-B ASSEMBLY
GO TO
NEXT PAGE
GO TO
NEXT PAGE
START
HERE
Traditional
3-Light Fitter
Compatible with:
2xxxx Types A - Z
51000-58999 fan series
59500-59999 fan series
Select Casablanca Fans
Switch
Housing
Cap
Switch
Housing
Assembly
Screw
Switch
Housing
Screw
Plug
Button
OR OR
Models 99134, 99135, 99136,
99138, 99140
If your fan’s switch housing cap
resembles this one, remove the whole
switch housing by removing the switch
housing screws with a Phillips head
screwdriver. Remove the two cap screws
from the inside of the switch housing.
Reinstall the switch housing. Tighten
the switch housing screws. Then follow
the instructions for TYPE-A ASSEMBLY.
OFF
Turn Power
Wire
Connector
Switch
Housing
Feed the light kit wires through the center hole
in the switch housing. Then attach the switch
housing to the light kit by installing the light kit
screws into the bottom of the switch housing.
Light Kit
Screw