Operation Manual

VIEW VERSION AND STATION SIZE

Turn to Advanced Features dial position.

Press and hold the Information button.

This will display contact information for help. This

information is programmable at the Set Station and

Program Names dial position, if you wish to change it.

FP Temp is the internal facepack temperature. It is not used

and is informational only.

The Revision number is the version of ACC firmware loaded

in the controller. You can download the latest version of

firmware from www.hunterindustries.com and flash update

the controller facepack from a laptop computer.

Please note this version number whenever asking a

question from technical support about the ACC controller.

Station Size: Shows the number of station outputs

recognized by the facepack. This does not show how many

valves are in the field, or in use. It is the count of station

output modules (number of ACM600 or AGM600 modules x

6 stations each), or it will show “99” if an ADM99 Decoder

Output module is detected.

If station size is incorrect, or shows “0” or “1”, check that

Powerlock slide is in the ON (locked) position. Check that

all station module contacts are in good order and that the

modules are fully inserted. Make sure powerlock tabs on

front of modules have good contact with the slide lock. An

incorrect station count may indicate a damaged module, if

it persists after all checks have been made.

When the info button is not pressed, the Advanced

Features may show all or some of the following items:

Utility Functions: ET Functions (only if ET Ready Master

Module and firmware are installed)

Event Mode Options: See Event Mode Options (agc,

surveyor) on page 75 for more information. (Golf only).

Decoder Functions (only if ADM99 decoder output module

is installed)

When viewing these menu selections, the left arrow button

on the facepack will operate as a Back button. Some

selections lead to another list of choices, and the Back

button will return you to the next highest level, without

having to turn the dial.

Select Utility Functions to see the following choices:

View Firmware Versions: Select to see version numbers of

all modules in use in the controller.

View Sensor Status: This will show the location and status

of the flow meter and all sensor inputs (1-4). CON means

Controller, or the screw terminals for sensor connections

inside the controller.