Use and Care Manual

OPERATING INSTRUCTIONS

Fan Operation

1. Set the Fan Base on a dry, level surface.

3. The SPEED is adjusted by turning the Speed

Control Switch to 1 or 2.

2. Plug cord into any standard 120 volt AC

outlet. Make sure the Speed Control Switch

is in the ‘0’ (Off) position.

61806-01 20190228

Control Panel

Warning! Electrical Hazard! Risk of re.

Replace fuse only with 2.5 Amp, 125 Volt fuse.

If the product fails a second time, immediately

unplug it and contact our technical support at

1-888-880-3267.

Figure 3.

4. Gently push the fuse back into the pins that will

hold it in place.

Note: If the fuse is not seated properly, the unit

will not function.

5. Close fuse cover. Slide closed the fuse access cover on top of attachment plug.

6. Plug the fan back in and resume use. Risk of re. Do not replace attachment

plug. Contains a safety device (fuse) that should not be removed. Discard

product if the attachment plug is damaged.

3. Turn fuse holder over to remove fuse. Remove

fuse carefully. Figure 3.