Use and Care Manual

7
WALL MOUNT INSTALLATION (OPTIONAL)
61806-01 20190228
Figure 4.
Figure 5.
Figure 6.
Figure 7.
Tools Necessary
You will need the following tools and accessories to
assemble the wall mount:
Pencil
Hammer
Phillips
screwdriver
Screws and Anchors or
Mounting screws x 2 (M4.5 x 50mm)
(***Note: Hardware to mount bracket is not included.
Please use appropriate hardware based on the type
of wall the unit is being mounted to.)
Drill
Step
Ladder
Drill Bit
Measuring tape
3.94"
3. Depending on purchased hardware size, drill pilot holes
using a drill bit. Insert the 2 anchors and screws into the wall
if applying into drywall. (Figure 5) You will not need an
anchor if applying into a stud. Use a screwdriver to ensure
the screws are approximately 1" between the screw head
and the wall. (Figure 6)
Wall Mount Installation Instructions
1. Unplug the fan from the electrical outlet before installation.
WARNING: Failure to disconnect power supply prior to
installation may result in serious injury or death.
CAUTION: To prevent the fan from falling off, do not install
it on walls less than 4 inch thick or made of materials that
are easily damaged.
2. This fan should only be mounted on an indoor wall. This
fan should only be mounted on an indoor wall. Select a
desire wall for mounting the fan. Use a pencil to mark the
hole locations with length of 3.94” (10cm). (Figure 4) Make
sure the holes are level.
Screws
Important: Make sure the anchors and screws can support
up to 30 lbs if not installing in a stud.
4. Attach the fan onto the screws on wall by slipping the
screws to the upper ends of the "L" holes (Figure 7).
Level