Operation Manual

ManualsBrandsHunter ManualsControl panelX-CORE

Installation of the X-Core

should only be done by trained personnel.

1. Route valve wires between the control valve location and controller.

2. At valves, attach a common wire to either solenoid wire on all

valves. This is most commonly a white colored wire. Attach a

separate control wire to the remaining wire of each valve. All wire

connections should be done using waterproof connectors.

3. Route the valve wires through the conduit. Attach the conduit

through the bottom right side of the controller.

4. Secure the white valve common wire to the C (Common) screw on

the terminal strip. Attach each of the individual valve control wires

to the appropriate station terminals and tighten their screws.

5. Indoor Models: route the transformer cable through the hole on the

le side of the controller and connect the wires to the two screws

marked 24VAC.

Outdoor Models: transformer wires are already connected to the

AC terminals so all that is required is to connect primary power to

the junction box (see below).

NOTE: X-Core

outdoor models are water and

weather resistant. Connecting the outdoor X-Core

to primary AC power should only be done by a licensed

electrician following all local codes. Improper installa

tion could result in shock or re hazard.

BAT

High Voltage Wiring (Outdoor Model only)

1. Route AC power cable and conduit through the ½" (13 mm) conduit

opening on the le side bottom of the cabinet.

2. Connect one wire to each of the two wires inside the junction box.

The ground wire should be connected to the green wire. Wire nuts

are provided to make these connections.

Note: For –E models only: Connect the wires to the AC

terminal block inside the junction box. AC supply wires must

be 14 AWG (1.85 mm) or larger with appropriate circuit breaker for

the wire size. A switch or circuit-breaker shall be included in the

building installation (in close proximity to the controller, within

easy reach of the operator) and marked as the disconnecting de

vice for the equipment.

3. Replace the junction box cover.

Connect the two transformer

wires to the two AC Terminals

Valve Common Wire

Valve 4

Valve 3

Valve 2

Valve 1

Valve

Wires

CONNECTING VALVES AND TRANSFORMERS