HIGH VELOCITY METAL WALL MOUNT FAN 20" AMPS: 1.
WARNING When using electrical appliances, basic precautions should always be followed to avoid the risk of fire, electric shock and injury to persons. Including the following: 1. Only use this fan as described in this manual, to reduce the risk of electrical shock or injury 2. To protect against electrical shock, do not immerse unit plug or cord in water or spray with liquids. 3. Only plug the unit into a power outlet with the same voltage as shown on the fan specification 4.
INSTALLATION REPLACEABLE FUSE The plug is a safety feature, it contains a safety device (fuse), if your replaceable fuse (5 Amp, 125 Volt) blows, please follow below instructions to replace the fuse. 1. Unplug your fan, and from the receptacle otherthe outlet device. 1. Mount wall bracket to grasp a studplug using theremove three 1¾ screws (included).orAlign three center Do not unplug by pulling on cord. mounting holse with the selected wall stud (Fig. 2). 2.
INSTALLATION 2. Screw in the top two fan mount screws into mount, leaving space for the fan to hang. Carefully hang the fan using the keyholes in the top hanging points for the fan. (Fig.3). Wall Stud Wall (Mount) (Fig.
INSTALLATION INSTALLATION 3. Tighten 3. Tighten down all down four all mounting four mounting screwsscrews securlysecurly to the wall to the mount wall bracket mount bracket (Fig 4).(Fig 4). 1. 3. 1. 2. 3. 2. 4. 4. (Fig.4) (Fig.4) OPERATION OPERATION The unitThe canunit be can usedbealone usedoralone in conjunction or in conjunction with anwith air conditioner an air conditioner to circulate to circulate cooled cooled air air or forceorthe force air into the air other intorooms. other rooms. 1.
WARNING OSCILLATION When using electrical appliances, basic precautions should always be followed to avoid the risk fire, the electric shock and injury to persons. Including following: Toofallow fan to oscillate, push the knob down on thethe motor housing. Pull up the knob if oscillation is not desired. knob for oscillation control 1.
INSTALLATION REPLACEABLE FUSE The plug is a safety feature, it contains a safety device (fuse), if your replaceable fuse (5 Amp, 125 Volt) blows, please follow below instructions to replace the fuse. 1. Unplug your fan, grasp plug and remove from the receptacle or other outlet device. not unplug by pulling cord. 1.Do Mount wall bracket to a on stud using the three 1¾ screws (included). Align the three center 2. mounting Sliding open fuse cover at the side of stud the plug holse with the selected wall (Fig.
HIGH VELOCITY METAL WALL MOUNT FAN 20" Part #736474 Exclusively distributed by:
