Installation Manual

INSTALLATION
The installer must read the following instructions very carefully before
using the product. The manufacturer will not be held responsible for injury
to persons or damage to property due to improper use with reference to
the precautions outlined in these instructions.
Do not exhaust hazardous or explosive vapors. For general ventilation
use only.
The device must be installed by a professionally qualified electrician in
accordance with all applicable codes and standards, including fire-rated
construction.
To ensure optimum operation, do not block the air intake and exhaust
vents. CAUTION: this unit has an unguarded impeller. DO NOT use in
locations readily accessible to people or animals.
MODE OF INSTALLATION
Wear gloves to safely move and/or install this inline fan.
Secure the Hurricane Inline Fan with clamps when attaching ducting
(see Fig.1).
The wiring diagram is directly under the contact box cover (Fig.2).
When all electrical connections are complete, check that the connection
terminals are securely tightened, close the box lid and start the inline fan.
NOTE: Because this fan comes pre-wired with a standard 120 volt power
cord, no additional wiring modifications are necessary
After the inline fan has started, check to make sure:
- The rotation direction is correct.
- The absorbed current corresponds to the rating.
- Excessive vibrations compromise the appliance stability.
KEEP THESE INSTRUCTIONS READILY AVAILABLE
GENERAL PRECAUTIONS
The use of electrical devices require compliance with these basic rules:
• DO NOT touch the device with wet hands, wet clothing, etc.
• NEVER allow the unit to directly contact wet or moist environments.
• DO NOT allow the product to be operated by children or unskilled people.
• NEVER place anything near or in the intake or exhaust ports of fan.
Connect the product to the main power supply or electrical outlet only if:
Your electrical voltage and frequency corresponds to those shown on
the rating plate.
The main power supply is sufficient to operate the product at its
maximum power.
If power supply is not sufficient, contact professionally qualified personnel.
It is recommended that the product is switched off when not in use.
Before carrying out any maintenance or cleaning, disconnect from the
power supply.
If a fault, malfunction or anomaly of any type occurs, disconnect from
power supply and immediately contact qualified personnel.
Always request original parts for any repairs.
If the product needs to be removed, turn off main circuit breaker and
then disconnect the device from that circuit.
Place the device in a safe location far from children and/or pets.
The electrical system to which the fan is connected must comply with
the current standards & codes regarding electrical systems for the parts
concerning the application of our devices.
SPECIAL PRECAUTIONS
The Hurricane Inline Duct Fan is professionally manufactured and
complies with the current standards regarding electrical equipment.
Do not use the product at an ambient temperature greater than
40˚C (104˚F).
Do not allow the product to be exposed to rain, sun, snow, etc.
Do not place the device or relative parts in water or liquids.
When cleaning or performing routine maintenance, check the condition
of the device. Please see Maintenance Section for proper cleaning.
To avoid risk of fire, do not use the product in the presence of flammable
substances or vapours such as alcohol, insecticides, gasoline, etc.
FIGURE 1
FIGURE 2