Owners manual
09021 2 SIDED.doc1
Rev: 0
Figure 3 Figure 4
4) Position Gear Box in vehicle as shown below (Figure 3). Note that safety strap will be aligned with jack tools
pouch.
5) With Gear Box in place, feed the loose end of the safety strap through the jack tools retaining bracket and then
into the strap lock, pulling it tight. Finally, fasten lock and pull firmly on the strap to make sure the strap and the
strap lock has been properly fastened (Figures 2 & 4).
6) Install the 2 dividers and you are ready to organize (Figure 3).
If you are storing long items it may be necessary to remove the dividers. Also, small loose items can potentially roll
around and become annoying. Simply place these items in a rag, towel, etc… roll them up and place in the Gear
Box.