Owners manual

PART NO. 5813

View the Husky Liners

Lifetime Warranty at www.huskyliners.com/lifetime-warranty. 5813 2019 Ram Front Flares

Instructions (2 SIDED DOC)

Patent and Trademark can be found at www.hl-ip.com

Rev: 0

pg. 1

RAM 1500

WITH FENDER FLARES

FRONT MUD GUARD INSTALLATION INSTRUCTIONS

Install Paint Protection Film before mud guards (see other side)

Please read instructions thoroughly before installation.

Tools Required

• 1/8” Drill Bit / Drill (optional)

• Short #2 Phillips Screwdriver

• 7/32 Socket / Driver

Package Contents

• Driver & Passenger Side Front Mud Guard

• #10 SEM Screw (qty. 2)

• Paint Protection Film (1 set)

• U-Clip (Qty 2)

• Instruction Sheet

NOTE: Turn the front wheels all the way to the left or right for mud guard installation. However, it may be necessary

to remove the wheels depending on the tools being used for installation.

Determine which mudguard you have by locating the part number molded in the mounting flange

(5813 DS and 5813 PS).

1. Clean and degrease the mud guard location area on the fender before installation.

2. Remove existing fasteners from locations A, B and C.

3. Peel red protective cover from the 3M adhesive on the mudguard.

4. Attach mud guard to front fender with factory fasteners at locations A, B and C, check fit and make sure mud guard is parallel to ground

before tightening. Be sure to press firmly on the area with the 3M adhesive tape to make sure adhesive is set.

OPTIONAL FASTENER INSTALLATION

5. Using the mud guard as a template drill 1/8” holes at location D

6. Install #10 SEM screw through the mudguard and fender liner. Use U-clip as a nut behind fender liner.

See Figure 2.

PAGE 1
PART NO. 5813 RAM 1500 WITH FENDER FLARES FRONT MUD GUARD INSTALLATION INSTRUCTIONS Install Paint Protection Film before mud guards (see other side) Please read instructions thoroughly before installation. Tools Required • 1/8” Drill Bit / Drill (optional) • Short #2 Phillips Screwdriver • 7/32 Socket / Driver • • • • • Package Contents Driver & Passenger Side Front Mud Guard #10 SEM Screw (qty.
PAGE 2
PART NO. 5813 PAINT PROTECTION FILM - INSTALLATION INSTRUCTIONS NOTE: The Paint Protection Film is a precut template of film used to protect the mud guard mounting surfaces of your fenders against wear. The templates (left and right side) can be removed from the backing liner by folding the liner at the center cut of the template, separating the film sides and peeling the film templates from the backing liner. 1. Position mud guard on fender to indicate placement location of paint protection film. 2.