Owners manual

Chevrolet Equinox Front Mud Guards PART NO. 5825

View the Husky Liners

Lifetime Warranty at www.huskyliners.com/lifetime-warranty. 5825 Equinox Front (2 SIDED DOC)FR1.doc

Patent and Trademark can be found at www.hl-ip.com Rev: 0

pg. 1

Please read instructions thoroughly before installation.

Tools Required

 Short Phillips screwdriver

 #15 Torx bit or wrench

 Drill / 1/8” drill bit

Package Contents

 Driver & passenger side mud guard

 #10 SEM Screw (2)

 U-clip (2)

 Spring Clip (2)

 Paint Protection Film (1 set)

 Instruction sheet

PAINT PROTECTION FILM INSTALLATION INSTRUCTIONS

NOTE: The Paint Protection Film is a precut template of film used to protect the mud guard mounting surfaces of your

fenders against wear. The templates (left and right side) can be removed from the backing liner by folding the

liner at the center cut of the template, separating the film sides and peeling the film templates from the backing

liner.

1. Position mud guard on fender to indicate placement location of paint

protection film.

2. Clean the placement area of fender with a clean cotton cloth and a

petroleum distillate based cleaner such as DuPonts Prep-Sol Brand Solvent

Cleaner or 3M Brand Adhesive Cleaner and dry.

3. Mix a wetting solution of 1 pint of water with 4 drops of liquid dishwashing

detergent.

4. Mark correct position of film by placing mud guard against fender. Make

sure film extends beyond edge of mud guard contour a minimum of an

1/8”.

5. Remove protection film from liner and flood adhesive side of film with wetting

solution (use a spray bottle or sponge).

6. Thoroughly wet film placement location of fender with wetting solution.

7. Position the adhesive side of film on fender and flood with wetting solution.

8. Check location of film with mud guard and reposition as necessary.

9. Using a sponge, squeegee any air bubbles and wrinkles from film.

10. Allow film to dry before installing mud guard.

PAGE 1
Chevrolet Equinox Front Mud Guards PART NO. 5825 Please read instructions thoroughly before installation.
PAGE 2
Chevrolet Equinox Front Mud Guards PART NO. 5825 MUD GUARD INSTALLATION NOTE: Turn the front wheels all the way to the left or right for mud guard installation. However, it may be necessary to remove the wheels depending on the tools being used for installation. 1 Remove existing fastener at location A. Do not discard. 2 Peel the red protective cover from the 3M tape on the mud guard. 3 Attach the mud guard at location A with the existing fastener. Check mud guard fit and alignment before tightening.