Owners manual

PART NO. 5846

5846 Front Instructions (2 SIDED DOC)F.docx

Rev: 0

FORD F250 / F350 SUPER DUTY

WITHOUT FENDER FLARES

FRONT MUD GUARD INSTALLATION INSTRUCTIONS

Install Paint Protection Film before mud guards (see other side)

Please read instructions thoroughly before installation.

Tools Required

 1/8” Drill Bit / Drill (optional)

 Short #2 Phillips Screwdriver

 7/32 Socket / Driver

Package Contents

 Driver & Passenger Side Front Mud Guard

 #10 SEM Screw (qty. 4)

 U-Clip (qty. 4)

 Paint Protection Film (1 set)

 Spring Clip (Qty 2)

 Instruction Sheet

NOTE: Turn the front wheels all the way to the left or right for mud guard installation. However, it may be necessary

to remove the wheels depending on the tools being used for installation.

Determine which mudguard you have by locating the part number molded in the mounting flange

(5846 LH 5846 RH).

1. Clean and degrease the mud guard location area on the fender before installation.

2. Remove existing fasteners from location B and C.

3. Peel red protective cover from the 3M adhesive on the mudguard.

4. Attach mud guard to front fender with factory fasteners at location B and C, check fit and make sure mud guard is

parallel to ground before tightening. Be sure to press firmly on the area with the 3M adhesive tape to make sure

adhesive is set.

5. Install the spring clip over the mudguard and the fender lip between the raised tic marks at location A.

OPTIONAL FASTENER INSTALLATION

6. Using the mud guard as a template mark and drill 1/8” holes at location A and D.

7. Install #10 SEM screw through the mudguard and sheet metal /fender liner and into the U-clip on the backside of

the fender lip / fender liner. (Note: The U-clip does not clip over the sheet metal, it acts as a nut on the backside of

the fender lip).

PAGE 1
PART NO. 5846 FORD F250 / F350 SUPER DUTY WITHOUT FENDER FLARES FRONT MUD GUARD INSTALLATION INSTRUCTIONS Install Paint Protection Film before mud guards (see other side) Please read instructions thoroughly before installation. Tools Required  1/8” Drill Bit / Drill (optional)  Short #2 Phillips Screwdriver  7/32 Socket / Driver       Package Contents Driver & Passenger Side Front Mud Guard #10 SEM Screw (qty. 4) U-Clip (qty.
PAGE 2
PART NO. 5846 PAINTING INSTRUCTIONS Note: If painting mud guards, perform a mud guard test fit to ensure correct fit and application prior to painting. 1. Clean mud guard with a soap and water solution to remove dirt and other contaminates. 2. Sand painting surface with 320 grit sand paper. 3. Apply a coating of flexible primer-adhesion promoter. 4. Apply a flexible paint as directed by the paint manufacturer.