Installation Manual

9958 Installation Instruction 3 pages with warranty

09/19/2013

CARE AND USE INSTRUCTIONS

Thank you for selecting a WeatherBeater® Floor Liner from Winfield Consumer Products. Your new front

floor liners are custom molded to fit your Toyota Tundra CrewMax truck. The liners are made to take the place

of your factory floor mats. For correct fit, it is necessary to remove the factory floor mats before installing

your new floor liners. However, do not remove the factory-installed carpeting.

Your liners are made from an engineering resin that is lightweight and extremely tough and durable. The

easiest way to clean your liners is with a damp cloth or sponge. If using a cleaner, 409

or Glass Plus

work

well. Use of Armor All

, Son-of-a-Gun

or similar items is discouraged as these products make the liners slick.

INSTALLATION INSTRUCTIONS FOR YOUR TOYOTA

TUNDRA CREWMAX FRONT FLOOR LINERS

BEFORE INSTALLING YOUR LINERS REMOVE ANY OTHER FLOOR MATS FROM THE VEHICLE.

BEGIN INSTALLATION BY MOVING YOUR FRONT SEATS TO THEIR MOST REARWARD POSITION. WITH

THIS DONE INSTALL THE DRIVER’ SIDE LINER ATTACHING IT TO THE FACTORY TWIST-LOCK

FASTENERS. IF YOU DO NOT HAVE TWIST-LOCK FASTENERS IN YOUR VEHICLE PLEASE CONTACT

YOUR RETAILER OR CALL HUSKY LINERS AT 800-344-8759. NOTE THAT THE LINER SETS OVER THE TOP

OF THE TWIST-LOCK FASTENER AND THEN THE TOP OF THE FASTENER IS TWISTED 90º TO SECURE THE

LINER IN PLACE (SEE ATTACHED PHOTO).

LEFT OR DRIVER’S

SIDE

RIGHT OR PASSENGER’S SIDE

PAGE 1
CARE AND USE INSTRUCTIONS Thank you for selecting a WeatherBeater® Floor Liner from Winfield Consumer Products. Your new front floor liners are custom molded to fit your Toyota Tundra CrewMax truck. The liners are made to take the place of your factory floor mats. For correct fit, it is necessary to remove the factory floor mats before installing your new floor liners. However, do not remove the factory-installed carpeting.
PAGE 2
IN YOUR PACKAGING YOU WILL FIND A COMPONENT BAG WITH A FASTENER THAT WILL BE USED TO SECURE THE PASSENGER SIDE LINER IN PLACE. LOCATE THE FASTENER IN YOUR PACKAGING, REMOVE THE FASTENER AND UNSCREW THE CAP FROM THE BASE (SEE IMAGE 1 BELOW). NEXT INSERT THE THREADED PORTION OF THE BASE INTO THE HOLE IN THE PASSENGER SIDE LINER, INSERTING IT FROM THE BACK SIDE OF THE LINER (SEE IMAGE 2 BELOW).
PAGE 3
CARE AND USE INSTRUCTIONS Thank you for selecting a WeatherBeater® Floor Liner from Winfield Consumer Products. Your new rear floor liner is custom molded to fit your Toyota Tundra CrewMax trucks. The liner is made to take the place of your factory floor mats. For correct fit, it is necessary to remove the factory floor mats before installing your new floor liners. However, do not remove the factory-installed carpeting.