Use and Care Manual

6
Pressure Regulator - Adjusts the line pressure to the proper amount needed to operate the spray gun or other air tools.
On/Off Switch - Turns the air compressor on and off. When the switch is in the ON position, it allows the motor to start if the
pressure in the air tank is below the factory set ‘cut-in’ pressure, and allows the motor to stop if the pressure in the air tank
reaches the factory set ‘cut-out’ pressure. Set this switch to the OFF position when the air compressor is not being used and
before unplugging the air compressor.
Tank Pressure Gauge - Indicates tank pressure in PSI.
Regulated Pressure Gauge - Displays the current line pressue. lt is regulated by the regulator knobs.
Connector - Connects the quick coupler.
Air Tank Drain Valve - Removes moisture from the air tank after the compressor is shut off.
Electric Motor - Powers the pump.
Air Compressor Pump - Compresses the air and discharges it into the tank via the piston moving up and down in the cylinder.
Pressure Relief Valve - Prevents system failure by draining pressure from the system when it reaches a preset level if the pressure
switch has not shut down the motor. lt will pop open automatically, or it can be activated manually by pulling the ring on the valve.
Power Cord - This air compressor should be used on a nominal 115 V grounded circuit. Use a power cord that is equipped
with a grounding plug. Verify that the air compressor is plugged into an outlet that has the same configuration as the plug.
Do not use an adapter with this air compressor.
Air Tank - Stores the compressed air.
MOC.SLOOTYKSUH
.ecnatsissa rehtruf rof YKSUH-DH-888-1 tcatnoc esaelP